@liamorourke I think it will not work with sliders for example.
For the grid you are sending "set 0 0 1" so the patch sends "format siii" to format.
I did it with a message
[;
format format siii(

but it could be
[format siii(
sent into [s format]

Anyway whatever the message you are sending you can send a format message first.
It applies to the message....... not the address like /fader
David.

@whale-av so does siii stand for symbol integer integer integer
where the symbol is the address... and then the three ints are the values?
eg. /flash 0 0 1

@whale-av I don't know about uploading to Android.
Do you actually put the Pd patch on the android device?
If so then maybe you don't need the wrapper.
Maybe the patch talks directly to the GUI and the OSC is no longer involved.
In which case the work we have done has only been for testing with the editor.

I obviously don't know much about Mobmuplat.
David.

@liamorourke No..... siii is for the message part...... set 0 0 1
Buy yes........ symbol and integer.
The address /flash is not involved.

To send /fader 2.837 you would just need "format f"
But for /fader set 2.837 you would need "format sf"

My bedtime...... hope it all works.
David.

okay... so i can define whether im sending integer or float from within the patch. that's good. You've been VERY helpful again David I really appreciate all this. take care

@liamorourke That's right.
I just tested your grid on my phone and it works.
The [pdwrapper] is just for testing the patch with the editor while you are developing it...... so it is not required when you upload the patch [grid] to Android.
So the messages to format can also be dropped from [grid] once you have completely finished the development and are happy with your patch.

BUT it looks like Mobmuplat might be designed to talk over a network at the same time to Pd on another device...... your computer?
If that is the case the wrapper would still be needed on the computer and the right hand side of the wrapper might need some modification.
I have a lot of reading to do.
I cannot get the wrapper to open the broadcast socket and talk to my phone yet...... probably a setting in my home routers will need to be changed.......
David.