Hi again,

I was not able to link up IAC Bus driver to NanoKontrol2 (NK2) properly from the Audio MIDI Setup on my Mac. However I found a rather cool solution using TouchOSC https://hexler.net/products/touchosc for the moment I replicated my NK2 and operating from my smartphone Android it communicates perfectectly.

Hi David,
No worries, I am trying it as you say. It might work,I hope!
Thank you so much
V.

Sure

It automatically gets "NanoKontrol2" as the 2 inputs, although I only have 1 midi controller plugged, no other port is used at the moment. So I normally change the input2 to "none". Then "Apply" and "OK" (then the window stays "freezed" open, cannot close it, but normally this is not a problem and I just ignore it)

I followed your link and its instructions to download Quartz, now the library loading problem is solved, thanks a lot!

V.

Hi again,

By any chance would this be a related issue?

/Applications/Pd-extended.app/Contents/Resources/Scripts/../extra/pdp/pdp.pd_darwin: dlopen(/Applications/Pd-extended.app/Contents/Resources/Scripts/../extra/pdp/pdp.pd_darwin, 10): Library not loaded: /usr/X11/lib/libX11.6.dylib
Referenced from: /Applications/Pd-extended.app/Contents/Resources/extra/pdp/pdp.pd_darwin
Reason: image not found
pdp: can't load library

Thanks in advance,

V.

@whale-av thank you ver much David!
The controller is for midi, I will keep on searching for further patches, I hope I am lucky
Best

Hi David!
Thank you very much for your helpful insight.

1 -"[pd nK2] is any data arriving for the sliders and buttons?" Yes, there is data only from the potentiometers and not accurate, if I turn slowly I get sudden changes like 127 - then 62 - then 2.

2 -"Maybe that is not the case for 10.14.6 if you have extended (32-bit only) running?" I can do run other patches and even the ones which serial communicate with my Arduino, etc.. but I am blocked with this one (I also upgraded MacOS almost at the same time as starting this tryouts.. that's why I am suspicious of this)

3 -"a factory reset would help" I am not familiar with this term, would this imply to send my KORG physically or more like restart or reinstall PD software?

4 - Very pretty, and maybe still valid....... nano2.pd Thank! it is super neat, I tried it, however there is data communication but I have the same data-wise issue as in point 1..

Thank you very much again for your feedback though,

Any other controller that gets on well with Pd? Also, I wonder if there is any specific version that works better with this kind of controllers.

Kind regards

Hi all, I am operating a Pd 0.43.4-extended version into a macOS Mojave 10.14.6 64-bit . I tried to plug NanoKONTROL2 KORG following this patch & instructions https://github.com/martin-leo/pure-data-korg-nanokontrol-2 fixed the broken links to the abstractions, but the entry signals from the NK2 Korg are not recognized, only the potentiometers (and not accurately), but no slider nor buttons..
I wonder if any other had the same issue and succesfully solved, or if any clue about 64-bit or Pd version being the potential issue...
Ps: My Nk2 is detected and works on MaxMSP7, so I guess the Nk2 nor port comm are the issue...