Hi Everyone
I've come across a small (and probably simple) problem whilst building a patch which reacts to my saxophone via a piezo disk. As you'll notice in the sub-patches one is using a [osc~] and the other [phasor~]. The problem I'm coming across is this ...
If I start up the patch first using the [osc~] sub-patch everything runs fine, as I expected. However, once I either use/change over to the [phasor~] sub-patch I am unable to go back to using just/alone the [osc~]. The [phasor~] becomes the prime object, or should I say osc~ and phasor~ run together.
a) Where am I going wrong?
Is there anyway I can disable phasor~in this case.
Big thanks in advance (see patch attached). I hope I explained the problem well enough.