Hello people!

I am trying to control the running of a video loop with a slider.

For this I am using [pix_film]. I load a video through the left inlet.
I am sending the numbers from my slider into the right inlet, and these numbers correspond to the frame number being displayed.

It works fine but there is a strange problem! When using a video with approximately 300 frames, only in the range of 1-10 - the beginning of the video, the image starts flipping upside down spontaneously... It not always in the same number, but only in the range 1-10. For higher numbers till 300 the video runs fine without flipping.

Does anybody know something about this problem? Any ideas of how to fix it??

Thanxxxxx

update -

I have discovered that there was a [pix_flip] object somewhere in the chain...
when I remove it, the problem is usually fixed, but sometimes everything gets flipped!
This object seems unstable or maybe there is some kind of noise in the stream of data that makes it go a bit crazy!

any insight regarding this issue would be appreciated

cheers