hi all,
I got a problem with...as the subject says: ableton to pure data to arduino.
My project is a robot band.

.. twenty servo motors controlled by the arduino board, I send the different values to the servos from pure data to arduino and pure data is controlled in midi from ableton live, I use Loopbe as my virtual midi to make the link beetween live and pd. I got 9 channels. My problem is quite strange because everything works just fine for 5 or ten minutes, and then it seems that the midi data are not sent or received the right way, the tempo changes, the servos start to behave wierdly, not synchronized anymore. The only way I found to make them work correctly again is to go in the midi settings of pd and say AGAIN to choose Loopbe as my input although it's still said that pd takes Loopbe as my input...???
if anybody could help me ..
thank you
manu

I also had similar problems with midi. Well, I tried to send midi the other way (from a hardware-controller to pd to ableton via midiyoke and Loopbe). It seemed like the midi data comming into PD got stuck after a few minutes and later it got all confused...
I also got a message like "Midiin is dangerous on windows". That was with PD extended. Today I tried vanilla and it did seem to work! I'm still testing but it looks good.