-
powersupply
@atarikai said:
You should check out the puredata FLOSS manual to get an understanding of how the PD interface works:
http://en.flossmanuals.net/pure-data/ch014_the-interface/
Once you're comfortable, then check out the section on OSC control:
This is great.. ^_^
-
powersupply
I'm very new to Pure Data and just found out about it through using touchOSC.
@hardtwill said:Consider switching to mrpeach's [routeOSC]
grid: version 0.8, written by Yves Degoyon (ydegoyon@free.fr)
error: [dumpOSC]: OSCx is deprecated!
Consider switching to mrpeach's [unpackOSC] and [udpreceive]
dumpOSC 8000
... couldn't createI had this exact same error and i notice by opening two patches (basic.pd & mix2-receive.pd can be found @hexler http://bit.ly/pmfwJO) both use dumpOSC 8000 and it will cause dumpOSC 8000 couldn't create.
Solution:
1. What I did import mrpeach as @atarikai & @Maelstorm suggested and also dumposc_setup.
2. Then duplicated basic.pd into mix2-receive.pd in edit mode which is putting new obj: sendOSC, print osc & dumpOSC=udpreceive; msg: connect,fader & print osc.
3. Done.