Hej Hej..!
I have a small project to connect my arduino with the solenoide control, with a attached board, and them make a sequencer in the Pd, for the solenoides, and control this sequencer by the APC. That is also sending messages to ableton live.
Well...so far I got the solenoides working fine with pd and arduino, and also a sequencer that send messages to the digital pins...
But i couldn´t find a way yet, to select a particular note in the APC to mark only that specific step.
the idea is:
when "pad1" is pressed, send 1. when is the other, do nothing.
when "pad1" is pressed again, send 0.
i mix a patch.
until now is like this:::