This is sort of a newbie question, but here goes:

I am using fiddle to get audio from my microphone and run it through synths, etc. The sounds resulting are very chaotic due to the changing numbers. My question is, how do I smoothly change from one number to the next? For instance, I want to smoothly change from 80 to 100 over a half-second or so. I know there must be a way to do this simply but I can't figure it out and I have been reading and reading everything I can find!!!!
Will someone please give a sort-of n00b some friendly advice?

@Thor said:

This is sort of a newbie question, but here goes:

I am using fiddle to get audio from my microphone and run it through synths, etc. The sounds resulting are very chaotic due to the changing numbers. My question is, how do I smoothly change from one number to the next? For instance, I want to smoothly change from 80 to 100 over a half-second or so. I know there must be a way to do this simply but I can't figure it out and I have been reading and reading everything I can find!!!!
Will someone please give a sort-of n00b some friendly advice?

Im also a noob & been PD'ing for about more than 3 weeks now but I think I can suggest this method as I use it to smoothly change tempos or volumes or any parameters that needs gradual transitions/changes.

|
[80( [100(
| /
| /
[pack f 500]
|
[line 0 5]
|

It's in the manual under grain rate of [line]. very useful, not sure how expensive would it be when use with any object~
hope it helps...

Thank you, I will try it right now!

hi
i sometimes let the frequency readings from fiddle run through a float f object before the line, connecting frequency value to the right inlet and eg the bang from the same fiddle to the left inlet so that just 1 value is passed through by the bang
vilbjørg

Thank you, those suggestions helped!