Hello,
I have been using PD for a while now, but I have not found much documentation that explains each aspect of [vcf~]
I understand that the first inlet is for the signal to be filtered and the third inlet is the Q amount.
The aspect of [vcf~] I need the most help understanding is that the second inlet controls multiple settings of the filter itself.
Specifically, I would appreciate an explanation of how to set the following:
Main cut-off frequency
Range in HZ above/below to allow
Usage of a LFO to control the filter
I appreciate any explanations that make this more straightforward.
Alternatively, an explanation showing how PD would implement the MiniMoog's basic filter knobs as input for [vcf~] would be great.
I understand that those settings are all basically determined by the second inlet to [vcf~] and that you need to apply different arithmetic objects into the same signal for the proper signal to go into the second inlet. Unfortunately, I haven't found much documentation that explains how to set the filter settings in that input signal.
Thank you!